CLICK TO PRINT - 2002 Toyota Camry Free Keyless Remote Programming
CLICK TO PRINT - 2002 Toyota Camry Solara Free Keyless Remote Programming
2002 CAMRY Programming (solara instructions below)
1. Begin with the key out of the ignition.
2. OPEN and UNLOCK the DRIVER'S side door. CLOSE all other doors including the trunk.
3. Within 5 seconds INSERT the key into the ignition and PULL it out TWICE. 4. CLOSE then OPEN the DRIVER's side door TWICE. 5. Insert key INTO the ignition then REMOVE it. 6. CLOSE then OPEN the DRIVER's side door TWICE. 7. Insert the key INTO the ignition and LEAVE it in ignition. 8. CLOSE the DRIVER's side door. 9. Switch the ignition to ON then OFF. 10. REMOVE the key from ignition. 11. The door locks will now cycle to confirm the vehicle has successfully entered programming mode. 12. PUSH and HOLD the LOCK and UNLOCK button for 1.5 seconds on the first remote being programmed. As soon as you let go PUSH the LOCK button and HOLD it for 2 seconds. 13. The door locks will cycle to confirm successful programming of the remote. If you have any additional remotes to program repeat step 12 if you have no additional remotes proceed to step 14. 14. OPEN the DRIVER'S side door. Programming is now complete.
2002 SOLARA Programming:
This procedure is for the FACTORY INSTALLED keyless entry system 1. Begin with the key out of the ignition. 2. OPEN and UNLOCK the DRIVER'S side door. CLOSE all other doors including the trunk. 3. INSERT the key into the ignition and PULL it out. 4. Locate the driver's side door lock/unlock switch. 5. LOCK and UNLOCK the switch 5 times. Try to pace yourself to 1 second for each LOCK and UNLOCK sequence. (hint: LOCK and UNLOCK = 1 time in 1 second) 6. CLOSE and OPEN the DRIVER'S side door. 7. LOCK and UNLOCK the switch 5 times. Try to pace yourself to 1 second for each LOCK and UNLOCK sequence. You will have 50 seconds to complete steps 7-10 (hint: LOCK and UNLOCK = 1 time in 1 second) 8. INSERT the KEY into the ignition. 9. Switch the ignition to ON then OFF TWICE (on is just shy of starting the car) 10. REMOVE the key from the ignition. 11. The door locks will cycle (lock and unlock) to confirm successful entry into programming mode. 12. PUSH and RELEASE the LOCK and UNLOCK button on the first remote you are programming at the SAME TIME (does not matter which remote you program first) 13. As soon as you let go PUSH and HOLD the lock button on the same remote for 2 seconds. The door locks will cycle to confirm successful programming of the remote. 14. Repeat steps 12 and 13 for each additional remote you wish to program. If you have no additional remotes to program proceed to step 15. 15. Close the DRIVER'S side door. Programming is now complete.
|
Order Now: Click to chat
