Included:	2 Complete remotes with electronics and battery
Condition:	New, never used replacement part
Replaces P/N:	N/A
For FCC ID:	HYQ1AA
Insert Key:	Included
Programming:	Self programmable. Programming guide included with purchase.

• 2018 - 2020 GMC Terrain
• 2015 - 2019 GMC Yukon
• 2015 - 2019 GMC Yukon XL
• 2015 - 2019 Chevrolet Suburban
• 2015 - 2019 Chevrolet Tahoe

This feature is not available in Canada. Takes approximately 30 minutes to complete. The vehicle must be turned off and all transmitters to be programmed must be present.

1. Remove the vehicle key from the transmitter.

2. Insert the vehicle key into the key lock cylinder on the driver's door handle. Turn the key counterclockwise to the unlock position 5 times within 10 seconds. The Driver Information Center (DIC) will display REMOTE LEARN PENDING, PLEASE WAIT.

3. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN, then press the ENGINE START/STOP button. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.

4. Repeat step 3 two additional times. After the third time all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show READY FOR REMOTE #1.

5. Place the new transmitter in the transmitter pocket/insert. Open the center console storage tray. The transmitter pocket/insert is in front of the storage area next tot he center console storage area between the driver and front passenger seats.

6. Press the ENGINE START/STOP button. When the transmitter is learned, the DIC display will show that is ready to program the next transmitter.

7. Remove the transmitter from the transmitter pocket/insert and press Lock button on the transmitter. To program additional transmitters, repeat steps 5-7. When all additional transmitters are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.

8. Return the key back to the transmitter.