Home > Chrysler > 2009 > PT Cruiser
Key Fob Keyless Entry Remote for 2009 Chrysler PT Cruiser
Sort By:
1
New Just the Case Keyless Entry Remote Clicker Car Key Fob Shell Replacement for OHT692427AA
Price with Free Shipping: $7.95

Replacement shell and button pad only
New Just the Case Keyless Entry Remote Clicker Car Key Fob Shell Replacement for OHT692427AA
Price with Free Shipping: $7.95

Replacement shell and button pad only
Keyguardz Keyless Entry Remote Key Fob Cover Skin Jacket Protector
Price with Free Shipping: $7.99

Protective silicone protective jacket
New Just the Case Shell Keyless Entry Remote Control Car Key Fob Replacement for KOBDT04A
Price with Free Shipping: $9.95

Replacement shell and button pad only
New Replacement Transponder Ignition Chip Key for 46
Price with Free Shipping: $9.95

Replacement transponder key
New Keyless Entry Remote Head Control Car Key Fob Replacement for KOBDT04A, OHT692427AA
Price with Free Shipping: $24.95

Complete key fob with electronics and a battery
New Keyless Entry Remote Head Control Car Key Fob Replacement for OHT692427AA 3BTN
Price with Free Shipping: $39.95

Complete key fob with electronics and a battery
   
 
1

Keyless Remote Key Programming Procedure:

Click to Print - Keyless Remote Key Programming Procedure
  • You must have two working programmed keys to perform this procedure. If you do not have two working original keys you will need to have your new key programmed at a dealer or auto locksmith.
  • MOST 2010+ vehicles are dealer or auto locksmith program only! (this procedure may work depending on your trim level)

  • 1. Insert first programmed key into ignition and turn ignition switch to ON for 5 seconds. Do not exceed 15 seconds.
    2. Turn ignition switch to OFF and remove key.
    3. Insert second programmed key into ignition and turn ignition switch to ON. You must do this within 15 seconds of removing first key. After 10 seconds the immobilizer warning lamp will illuminate and an audible tone will be heard.
    4. Turn ignition switch to OFF and remove key.
    5. Within 60 seconds insert new un-programmed key into ignition and turn ignition switch to ON.
    6. After 10 seconds an audible tone will be heard and the immobilizer warning lamp will illuminate for 3 seconds.
    7. Turn ignition switch to OFF and remove key.
    8. For each additional key to be programmed you must start at step 1 and follow procedure again.You can have up to 8 keys programmed to vehicle.

    Copyright © remotesremotes.com. All Rights Reserved.